Each transmitter can use one of 65,536 unique security codes.

It may be necessary to program the remote receiver to LEARN the security code of the transmitter upon initial use, if batteries are replaced, or if a replacement transmitter is purchased from your dealer or the factory. When matching security codes, be sure slide button on the receiver is in the REMOTE position; the code will NOT "LEARN" if the slide switch is in the ON or OFF position.

REPROGRAMMING YOUR REMOTE RECEIVER TO LEARN A NEW SECURITY CODE:

Push and Release the LEARN button on the top of the remote receiver and then Press the ON or OFF button on the transmitter. A change in the beeping pattern, at the receiver, indicates the transmitter's code has been programmed into the receiver. When an existing receiver is matched to a new transmitter, the new security code will override the old.

The microprocessor that controls the security code matching procedure is controlled by a timing function. If you are unsuccessful in matching the security code on the first attempt, wait 1-2 minutes before trying again - this delay allows the microprocessor to reset its timer circuitry - and try up to two or three more times.